Setup

Firmware and memory slots

Firmware and memory slots cover

People mix up two writes to the same device. One of them updates the Zen. The other one stores the script. They use different ports and different buttons.

Firmware

Firmware is the Zen’s own software. Cronus’s current instructions say to unplug every cable, hold the small blue button on the back, and plug into the top port while you are still holding. Zen Studio Live then offers Update Firmware. You do not pull the cable halfway. A half-written firmware is a worse afternoon than a bad script value. The steps are on start Zen Studio Live.

A script slot

A .gpc is not firmware. It lives in one of eight memory slots. The cable for that job is the PROG port, without the blue-button dance. You send the file to an empty slot and program. When it finishes, unplug PROG before you play. Overwriting a slot replaces what was there. It does not update firmware.

Build and Run in the compiler can exercise a file while you are still at the desk. The slot you take to the couch is the one you programmed.

If a download from a seller fails, the fix is the account that sold it. For a yew script that is Script Download on the seller. The slot cannot invent a file the account does not have.

Before you buy

How many script slots are there?

Eight. Programming a slot replaces what was in it. It does not write firmware.

Which port updates firmware?

The top port, while holding the blue button, with every other cable unplugged. PROG is for scripts.